Enmet RECON Series Bedienungsanleitung

ENMET Corporation PO Box 979 Ann Arbor, MI 48106-0979 Manual Part Number 80006-018 MCN-440, 08/23/10 RECON Manual

RECON ENMET Corporation 8 5.0 Maintenance of the RECON To maintain proper battery function and life the Recon should be operated once a week for

RECON ENMET Corporation 9 5.1.3 Calibration Point Adjustment In this mode, display is the last concentration of gas used to calibrate the instrum

RECON ENMET Corporation 10 5.2 Alarm Levels Adjustment of the RECON 5.2.1 Set up of L-alarm (Low Alarm) With the RECON Off press and hold the POW

RECON ENMET Corporation 11 6.0 Specifications and Troubleshooting Tips 6.1 Specifications Electrical Power Working Voltage 3.6VDC Lithium batter

RECON ENMET Corporation 12 8.0 WARRANTY ENMET warrants new instruments to be free from defects in workmanship and material under normal use for a

PO Box 979 680 Fairfield Court Ann Arbor, Michigan 48106-0979 734.761.1270 Fax 734.761.3220 Returning an Instrument for Repair ENMET instrument

Repair Return Form Mailing Address: ENMET Corporation PO Box 979 Ann Arbor, Michigan 48106 Phone Number: 734.761.1270 FAX Number: 734.

Table of Contents 1.0 INTRODUCTION...

RECON ENMET Corporation 1 1.0 Introduction The RECON is a portable-single gas detector for detection of combustible or toxic gases. It is intend

RECON ENMET Corporation 2 2.0 Features 2.1 RECON Features See Figure 1 for location of features: FEATURE DESCRIPTION 1 Visual Alarms Red indi

RECON ENMET Corporation 3 LCD, DISPLAY NUMBER FUNCTION 1 Battery 2 Lock 3 sound 4 vibration 5 Alarming conditions 6 Warning or the maxi

RECON ENMET Corporation 4 4.0 Operation 4.1 Activation of the RECON To activate the detector, press the POWER button and hold for 3 seconds. T

RECON ENMET Corporation 5 4.3 Checking RECON Status To activate the detector, press the POWER button and hold for 3 seconds. When the RECON ha

RECON ENMET Corporation 6 4.5 Alarms When alarming continuously, you can press SET button to turn off the audible alarm and vibration when the

RECON ENMET Corporation 7 Time error In this condition, the device will try to renovate it by itself. If succeeded, after start-up, it enters in