Enmet AM-5175 Bedienungsanleitung

ENMET Corporation PO Box 979 Ann Arbor, MI 48106-0979 www.enmet.com Manual part number 80003-551 MCN-14-003, 03/20/14

AM-5175 ENMET Corporation 8 4.2 Normal Display Mode When the AM-5175 is installed as described in section 3, and in clean air, the POWER green LE

AM-5175 ENMET Corporation 9 5.0 Maintenance The AM-5175 maintenance menus are accessed by pressing the MENU button and SELECT button as described

AM-5175 ENMET Corporation 10 NOTE: Software revision may cause variations of display output. Normal Gas Display 5ppm MenuPress and Hold t

AM-5175 ENMET Corporation 11 5.2 Calibration of the AM-5175 Calibration is the process of setting the instrument up to read accurately when expos

AM-5175 ENMET Corporation 12 5.2.1 Exit Maintenance Menu Exit maintenance, by pressing the Exit appears on the display. Press the SELECT button

AM-5175 ENMET Corporation 13 5.2.3 Gas Span It is recommended that the Zero Function be performed first. Do not perform a calibration unless span

AM-5175 ENMET Corporation 14 5.2.4 Alarm Set Points The AM-5175 has three alarm set points set at the factory. These alarm points are normally s

AM-5175 ENMET Corporation 15 5.3 Sensor Replacement WARNING: Power must be removed from the AM-5175 before this or any internal procedure. Failu

AM-5175 ENMET Corporation 16 6.0 Accessory and Replacement Parts ENMET accessory part numbers: Part number Description 03620-022 Calibration

AM-5175 ENMET Corporation 17 8.0 WARRANTY ENMET warrants new instruments to be free from defects in workmanship and material under normal use for

Table of Contents 1.0 Introduction ...

PO Box 979 680 Fairfield Court Ann Arbor, Michigan 48106-0979 734.761.1270 Fax 734.761.3220 Returning an Instrument for Repair ENMET instrument

Repair Return Form Mailing Address: ENMET Corporation PO Box 979 Ann Arbor, Michigan 48106 Phone Number: 734.761.1270 FAX Number: 734.

AM-5175 ENMET Corporation 1 1.0 Introduction The AM-5175 is an ambient air monitoring instrument that measures and detects gases utilizing electr

AM-5175 ENMET Corporation 2 2.0 Components of the AM-5175 2.1 AM-5175 elements See Figure 1 for location of elements: Feature Description Enclos

AM-5175 ENMET Corporation 3 2.3 Circuit Board Features The Display Panel is attached by a cable and is released by unscrewing the 4 screws locate

AM-5175 ENMET Corporation 4 3.0 Installation of the AM-5175 The AM-5175 is supplied with a strain relief and a standard U.S. 3 prong power line c

AM-5175 ENMET Corporation 5 3.1.1 Wiring the AM-5175 The electrical installation should conform to appropriate electrical codes, such as the Nati

AM-5175 ENMET Corporation 6 3.3 Relay Contacts Relay contacts are available for each alarm; these are SPDT, rated at 10Amp at 110VAC, and may be

AM-5175 ENMET Corporation 7 4.0 Operation When the AM-5175 is installed as described in Section 3, and in clean air, the POWER green LED is on, t